sanguinarypc said:
minihack said:
Thanks to all of you I have got my Nvidea 560 GTX Ti working with my onboard HD3000 on my Z68 board. Here's a link to my step by step based on the knowledge from Toleda and mmaenpaa and SanguinaryPC.
http://www.tonymacx86.com/viewtopic.php?p=386687#p386687
My system profiler does not show the HD3000, nevertheless it is working.
small question !!!!
on my setup i need after a Shut Down to set bios again ,
do you have the same problem or is permanent to you ,
i mean that always after a shut down all your monitors working with out to change the bios setting again ?
Yes, it sucks big time. I have to unplug main card, set the HD3000 as Init Display first, boot into the HD3000 graphics and then shutdown, set BIOS for the PCI-E and restart into the main graphics card. I can then hot plug Onboard HDMI HD3000 and it works. However after a shutdown you need to do it all again.
Get it wrong and you get the screen being garbled on HD3000 or a KP. This is a repeatable sequence though, so some genius out there should be able to work out what is going on.
I did try lots of things such as rebuilding kernel caches while the two screens were working and then setting UseKernelCache=Yes.I hoped that this would preserve a good configuration but it seems that it does not help.
I have now gone to DSDT injection for my main graphics card (no longer using graphicsenabler=yes) and am hoping to find some key I can inject that will prevent the panic that happens on HD3000.