Gigabyte GA-H81M-HD3, i5-4430 Errors

[DC2Light]

Hello it's been a while since I've done a build and visited this great site. It's only my fourth build but my first Haswell and I've run into a few problems. Yes I've read all that I could find and after great effort was able to finally install 10.9.3 but still can not boot into the drive on its own without my unibeast boot. I followed this thread http://www.tonymacx86.com/mavericks...ga-h81m-hd3-core-i3-4330-hd4600-graphics.html I used current versions of multibeast 6.3.1 and even swapped my single 8 gig HyperX Fury 1866 ram to a single 8 G-Skill 1333 (yes I know) but still boot 0 error and I get this. Any help would surely be appreciated. I can't figure it out. Again thanks in advance.

 

[ferdivdw]

Did you disable intel virtualization? try boot argument dart=0
The i3-4330 doesnt have vt-d the i5 has...

 

[DC2Light]

Hmm… first off thanks for reply. I am running an i5-4430 as stated so I did not turn off virtualization. (Am I wrong?) dart=0 got me in through with unibeast but then froze after a few minutes. I normally only get in there with -x maxmem=8192 and of course through unibeast only. I'm still very slow at this but always enjoy a challenge. Any more input would be great.
Cheers

 

[DC2Light]

Upon further head bashing upon a bed of nails I realized what you meant, thank you. First time I've dealt with a small 4k drive. (Toshiba part of the newegg package) So far all looks good. Btw I thought that PCIx support went out with Ivey Bridge? I will further explore Protools HD2 on this inexpensive Haswell platform. Thanks again.

 

[Joe43]

Hello it's been a while since I've done a build and visited this great site. It's only my fourth build but my first Haswell and I've run into a few problems. Yes I've read all that I could find and after great effort was able to finally install 10.9.3 but still can not boot into the drive on its own without my unibeast boot. I followed this thread http://www.tonymacx86.com/mavericks...ga-h81m-hd3-core-i3-4330-hd4600-graphics.html I used current versions of multibeast 6.3.1 and even swapped my single 8 gig HyperX Fury 1866 ram to a single 8 G-Skill 1333 (yes I know) but still boot 0 error and I get this. Any help would surely be appreciated. I can't figure it out. Again thanks in advance.

Hi,
I had exactly the same problem but Tony Mac describes in detail what to do if that occurs to you here:
http://www.tonymacx86.com/25-boot0-error-official-guide.html
Good luck, it works fine then after executing these codes.
Joe