FireWire on X299 10.13.06

[thedavep]

Hello,

Its been a while..
I'm tryin to enable a FW PCIe (T.I Chip) card in my build.

In system Information, under PCI, I can see the card, and it says that the driver is loaded.
But under FireWire it says "..No FireWire ports were found..", and Any device connected wont show up.

On the same system, when running Windows, the FW works fine.

please see attached a screenshot, and my clover config. file, and tell me whats wrong..

 

[jiffyslot]

FWIW, I've gotten Firewire to show up when it's hanging off of a Thunderbolt 2 device: It's using the Apple Thunderbolt 2 to Firewire 800 dongle. I pulled my Firewire card sometime ago: It was sitting in slot 3 of my mobo. It definitely worked in High Sierra (FW1394 driver initialized in Windows 10) but I can't recall if I used the card in Mojave. Hope this helps.

 

[thedavep]

THX. I get nothing at the Thunderbolt Tab either. Did you use spacial .kext other then the ones in S/L/E (stock)?

 

[thedavep]

My Board dont have ThunderBolt 2/3. Just USB-C.