- Joined
- Nov 9, 2016
- Messages
- 16
- Motherboard
- Dell Vostro V5459 / Aptio AMI Bios
- CPU
- I5-6200U
- Graphics
- Intel HD 520 + GTX930M / 1366x768
- Mobile Phone
Hello
So I finally (after a month of fighting with booting installer) have managed to successfully install macOS Sierra 10.12.
But there is sometimes a situation that Clover stops at:
and it's stuck forever.
After a lot of testing I found out what to do to make it boot again. (Same for installer)
So I am not 100% sure what is the reason of this problem and what makes it not boot, but my guess is some ACPI problem it may be in "invalid state" for the Clover.
To get rid of this "invalid state" I have to:
1. Disconnect charger if connected
2. Shutdown laptop
3. Wait for approximately 10 seconds.
After this sequence it as far as I tested it always boots.
What may be the reason?
So I finally (after a month of fighting with booting installer) have managed to successfully install macOS Sierra 10.12.
But there is sometimes a situation that Clover stops at:
Code:
reloc block: yes hibernation wake: no
After a lot of testing I found out what to do to make it boot again. (Same for installer)
So I am not 100% sure what is the reason of this problem and what makes it not boot, but my guess is some ACPI problem it may be in "invalid state" for the Clover.
To get rid of this "invalid state" I have to:
1. Disconnect charger if connected
2. Shutdown laptop
3. Wait for approximately 10 seconds.
After this sequence it as far as I tested it always boots.
What may be the reason?