Black Screen when trying to install mavericks from unibeast

[kevinallen]

I created a UniBeast USB and am attempting to load Mavericks on a computer i recently built.

every time i load it up, it gets to a certain point then my monitor shuts off.

ive tried every combination of flags i could find. nothing seems to be working

comp specs are

i7 4770k
Gigabyte z87x-d3h
32 gb corsair vengeance 1600 RAM (brought it down to 8 for install)
samsung 840 pro SSD (2)
GTX 780Ti

im also attaching an image of the last thing it says when booted into verbose

 

[kevinallen]

anybody?

 

[P1LGRIM]

Do you realise that boot flags are case sensitive ?

On your screenshot I see GraphicsEnabler=no but it should be GraphicsEnabler=No


Good Luck

 

[kevinallen]

Either way, isn't GraphicsEnabler=No already the default with the mavericks install?

 

[kevinallen]

Tried it again last night with the proper flags. still goes to black screen after the loading screen.

i also tried it with no flags and get the same thing. it loads, no kernel panic, but then goes to black. Im plugged in through DVI cable

 

[kevinallen]

I got it to install by removing my gtx 780ti.

I plugged in all my ram and rebooted. Working so far.

Plugged the gtx back in and rebooted, back to black screen.

Any idea Wtf is happening?

 

[P1LGRIM]

Have you disabled the integrated graphics in BIOS ?

 

[P1LGRIM]

This thread suggests booting with :

nv_disable=1



Good Luck

 

[chaoticmayhem65]

I had the same problem with my card. Had to use GraphicsEnabler=Yes because the latest Chimera defaults to No. But then again i have a legacy card (9800GT).

 

[kevinallen]

Thanks everyone. I'll try all these suggestions when I'm back from work and report back