- Joined
- Apr 30, 2017
- Messages
- 1
- Motherboard
- Z68 Fatal1ty Gen 3
- CPU
- i7 3770k
- Graphics
- Nv 1070
Hey all, I finally managed to get OS X sierra installed yesterday and almost everyone is working bar the nvidia drivers acting up and Clover. It seems clover is the one to fix first as the new NV drivers need some changes with Clovers config.
This is what my drive looks like:
Samsung SSD
Partition 1 - System Reserved Win 10
Partition 2 - Win 10 - Currently using MBR (this might be the problem)
Partition 3 - Sierra HFS+
Partition 4- Recovery Partition.
Currently i am booting Sierra off the USB i created to install it.
So here's the problem : I run multibeast and installed clover on my OS X partition.When booting, i actually have two entries for 'Mac OS X' in my boot options but these do nothing - just a blinking cursor. If Clover is installed on Sierra - where is it actually? Which main drive am i supposed to boot for Clover to show up - cause i've tried them all.
I also just tried using the Clover installer-i installed onto the Sierra partition as all others were not accepted. Now when i booth the OS X options from Bios - it loads Win 10.
This is what my drive looks like:
Samsung SSD
Partition 1 - System Reserved Win 10
Partition 2 - Win 10 - Currently using MBR (this might be the problem)
Partition 3 - Sierra HFS+
Partition 4- Recovery Partition.
Currently i am booting Sierra off the USB i created to install it.
So here's the problem : I run multibeast and installed clover on my OS X partition.When booting, i actually have two entries for 'Mac OS X' in my boot options but these do nothing - just a blinking cursor. If Clover is installed on Sierra - where is it actually? Which main drive am i supposed to boot for Clover to show up - cause i've tried them all.
I also just tried using the Clover installer-i installed onto the Sierra partition as all others were not accepted. Now when i booth the OS X options from Bios - it loads Win 10.
Last edited: