Yes, this is the guide that I am following.
I have some doubts with some parameters in the BIOS, I think that might affect the installation.
This is my configuration in the BIOS:
MAIN
BIOS Versión: BLH3710H.86A.0160.2012.1204.1156 (160)
Active Processor Cores: ALL
CONFIGURATION
Onboard Devices
Enhanced Consumer IR: Disable
Audio: Enable
Front Panel Audio: Disable
HDMI/DisplayPort Audio: Enable
LAN: Enable
Num Lock: On
PCI Latency Timer: 32
SATA Drivers
Chipset SATA: Enable
Chipset SATA Mode: AHCI
S.M.A.R.T.: Enable
SATA Port 0: ST500DM002-1BD (500.1GB-6.0Gb/s)
SATA Port 1: HL-DT-ST DVDRA (1.5Gb/s)
eSATA Ports: Disable
SATA Port X Hot Plug Capability: Disable
Hard Disk Pre-Delay: No
Event Log
Clear Event Log: No
Event Logging: Enable
Video
Integrated Graphics Device: Enable if Primary
IGD DVMT Memory: Maximum DVMT
Primary Video Adaptor: Auto
IGD Primary Video Port: Auto
No Video Detected Error Beeps: Disable
SECURITY
Chassis Intrusion: Log Only
Execute Disable Bit: Enable
Intel Virtualization Technology: Disable
POWER
Enhanced Intel SpeedStep Technology: Enable
Processor C States: Enable
After Power Failure: Stay Off
Wake on LAN from S4/S5: Power On - Normal Boot
S3 State Indicator: Blink
Wake System from S5: Disable
PCIe ASPM Support: Disable
Flash Update Sleep Delay: Disable
BOOT
Boot Menu Type: Advanced
Boot Drive Order: P0:ST500DM002-1BD142
Boot to Optical Devices: Disable
Boot to Removable Devices: Enable
Boot to Network: Disable
USB Boot: Enable
Boot USB Devices First: Disable
UEFI Boot: Enable
General Optimization: Disable
USB Optimization: Disable
Video Optimization: Disable
@RehabMan, Do you think?, There any parameter to be changed?
Thank You Very Much.
NOTE: thanks for the tip on the graphics card.