- Joined
- Apr 30, 2012
- Messages
- 85
- Motherboard
- GA-B75M-D3H
- CPU
- i5-2500K
- Graphics
- Intel HD3000
- Mobile Phone
Hey!
Just finished installing the macOS Public Beta preview. Followed this tutorial and was able to boot into my SSD using the Installation USB.
But I can't get my post-installation right. I'm having some issues with graphics and HDMI audio (but the latter I think I can fix later). My graphics card is the built-in from i5-2500K, the HD 3000. On El Capitan, I used to inject the device ID at IntelGFX, Devices and Properties at Device section on Clover.
Can't get it working on i) main SSD with Device ID injected, or ii) Installation USB with Device ID injected, or iii) main SSD without Device ID injected. However, Installation USB without Device ID injected works just fine. But without proper graphics card recognition (at 1024x768 resolution and HD 2000 3 MB graphics, but it should be HD 3000 384 MB).
I'm using two displays, one DVI and other HDMI (tried with only one plugged in and the problem persists).
My Clover version is v3599. Kexts: FakeSMC, NullCPUPowerManagement and RealtekRTL8111 at S/L/E and Clover /other folder, both at the Installation USB EFI and SSD's EFI as well. Config.plist and verbose's last line attached.
Any thoughts?
Just finished installing the macOS Public Beta preview. Followed this tutorial and was able to boot into my SSD using the Installation USB.
But I can't get my post-installation right. I'm having some issues with graphics and HDMI audio (but the latter I think I can fix later). My graphics card is the built-in from i5-2500K, the HD 3000. On El Capitan, I used to inject the device ID at IntelGFX, Devices and Properties at Device section on Clover.
Can't get it working on i) main SSD with Device ID injected, or ii) Installation USB with Device ID injected, or iii) main SSD without Device ID injected. However, Installation USB without Device ID injected works just fine. But without proper graphics card recognition (at 1024x768 resolution and HD 2000 3 MB graphics, but it should be HD 3000 384 MB).
I'm using two displays, one DVI and other HDMI (tried with only one plugged in and the problem persists).
My Clover version is v3599. Kexts: FakeSMC, NullCPUPowerManagement and RealtekRTL8111 at S/L/E and Clover /other folder, both at the Installation USB EFI and SSD's EFI as well. Config.plist and verbose's last line attached.
Any thoughts?
Attachments
Last edited: