Contribute
Register

Impossible installation Yosemite using Clover X58A-UD3R

Status
Not open for further replies.
ysko

ysko

Joined
Nov 26, 2010
Messages
93
Motherboard
Mountain Lion
CPU
i7 950
Graphics
NVIDIA GeForce GT 640 2048 MB
Mac
  1. MacBook Pro
Classic Mac
  1. eMac
Mobile Phone
  1. iOS
Hello everyone,

anyone has been able to install Yosemite using clover in that MoBo? For me it's impossible, I can't get to the installation screen (Yosemite) but I'm able to start clover screen but it's so weird because I installed clover and Yosemite in two different USB and with one of them I can get the clover install screen but with the other I can't.

Which bootflags should I use? I used -v cpus=1 npci=0x2000 apart from the kext-dev... that comes by default with no luck. I followed the main guide.

Thank you so much.
 
Build 1
GA-X58A-UD3R |  i7 950 |  GeForce GT 640
ysko said:
Hello everyone,

anyone has been able to install Yosemite using clover in that MoBo? For me it's impossible, I can't get to the installation screen (Yosemite) but I'm able to start clover screen but it's so weird because I installed clover and Yosemite in two different USB and with one of them I can get the clover install screen but with the other I can't.

Which bootflags should I use? I used -v cpus=1 npci=0x2000 apart from the kext-dev... that comes by default with no luck. I followed the main guide.

Thank you so much.
Click to expand...

With the X58A boards you have to remember to create your Clover USB installer with Legacy mode settings. X58A boards do not have UEFI - only legacy AMI BIOS.
I had no trouble following the guide - http://www.tonymacx86.com/yosemite-desktop-guides/144426-how-install-os-x-yosemite-using-clover.html - to create a Clover installer for Yosemite and installing on my X58A-UD7, the "big brother" of your X58A-UD3R.
 
Going Bald said:
With the X58A boards you have to remember to create your Clover USB installer with Legacy mode settings. X58A boards do not have UEFI - only legacy AMI BIOS.
I had no trouble following the guide - http://www.tonymacx86.com/yosemite-desktop-guides/144426-how-install-os-x-yosemite-using-clover.html - to create a Clover installer for Yosemite and installing on my X58A-UD7, the "big brother" of your X58A-UD3R.
Click to expand...

I followed the guide you post it and I used the settings on the images (I thought that was for legacy bios) isn't it?. If not, which settings I have to use?.

Thanks :)!.

EDIT: I used exactly this configuration
85982d1394225480-how-install-os-x-mavericks-using-clover-legacy-usb.jpg
 
Last edited by a moderator:
Build 1
GA-X58A-UD3R |  i7 950 |  GeForce GT 640
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top