Finally updated from El Capitan. Did a straight upgrade through the app store, then had a couple hiccups getting everything straightened out. Now on 10.12.1 but after each boot I get a blank window and cannot find the culprit. Anybody else get anything similar or have any advice? Rapport...
Excuse my confusion, by I'm not entirely sure how we're supposed to generate with CloverConfigurator when the MacMini7,1 that you use for our build is not an option. Are we supposed to manually input all the characters?
The only method I know to get a serial for the machine is via Clover Configurator, however it doesn't have the option for a MacMini7,1. Maybe Sebinouse can give us a heads-up on the best method?
Did a fresh install and after all steps rebooted. I get the usual apple load bar, which progresses very slowly and once it gets to the end just sits there, any ideas?
Awesome. I was also wondering, in minihack's thread you mentioned problem with using Clover Configurator for the config.plist. What would you recommend for editing the file for personalizing on my machine (such as serial number).
Which, if any are the differences on our hardware between the Osxaptiofix and Osxaptio2fix? BTW I'm going to start from scratch and do a fresh install with your guide and hopefully have a much more stable system. I'm thinking of switching my old wifi/BT card for the one you have listed. Does it...
Edit: Was able to install on a new SSD and when I reattached the mSATA I used disk utility first aid and the drive booted normally afterward. All is well with my machine again!
I'm at a standstill. I still am unable to get the computer to boot from my mSATA as earlier stated. Doesn't make it to the load bar before rebooting. I tried making a USB install from scratch and it wouldn't load until I removed the mSATA. Obviously the mSATA is creating problems for the boot...
Thank you for the help! No progress bar, I am in the newest Clover revision and I've been using AptiofixV2. I'll check the config.plist though I inserted the one posted above from your wiki!
Thanks for this post, my machine is pretty solid now. I've run into a speed bump though if anybody could help! After getting my system set up with your configurations I installed netgear readyshare software to print wirelessly across my network. After installation it rebooted and now I'm unable...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.