Recent content by Scifisteve

In reading the TonyMac install new steps went in a new direction at step "STEP 6: Alternate Post-Installation". I watched this step #6 done on a Youtube video. "https://www.youtube.com/watch?v=OMLCJ0JMK9Q" Has anyone done this method and had the problem continue? Steve

Congratulations The C-Stats are the trick. I change my “C” State (Under CPU Advanced) back in February I have not had a single freeze since that time !!!!! Its was so successful that I doubled the memory speed and Overlocked the CPU same month!!! I have not had a single freeze since February...

Okay you're the best. I have been trying since January to get my Hackintosh up and running. I've had limited success but never the amount of success that I have had since I've followed your instructions. Your BIOS and MultiBeast settings apparently are spot on. I've been running now for...

I have the GA-Z87X-UD5H Z87 LGA 1150 Finished the build back in January an have absolutely no reason to believe its a usable board. I've applied the suggested MultiBEAST. Hardware and OSX were a piece of cake. But I never run for more than a couple of days without freezing. Sometimes I...

My machine has never been over clocked. I running 2 Corsair Vengeance 16mg sat 1600 mhz. The greatest degree of success I have had is to go into System Preferences and taking the speakers to Digital Output (effetely taking them offline). No Failures for 9 days. Im retired so I start at 8:00...

Made Change with no difference. Ran 5 hours before freeze. But Im open to change If this is a clue my machine has run as long as five full days. Loaded down with just about everything up and running. And sometimes it freezes 5 times a day. Steve

I've been running for 3 days now, no freezes. I found Safari in my Utility Console file with Kernel statements saying he could not ID a file type (???). Tracing it back I linked the file request to a sound file. I got to the point where I could freeze the system on demand. I dropped Safari...

I to am freezing from time to time. I can perform the same steps and freeze time and not another. If I run one major App (lightwave) it seems to run fine. If I run 2 apps (lightwave and VUE) or more freezing is in my very near future. I have removed and run on just one memory stick with both...

Hi I have a Z87X UDH5, with the I7 processor. Im down to MultiBeast install. Of course no DSDT selected with this board. I have tried for 2 days different combinations, rebuilding my target disk each time, from just selecting the EasyBeast to DSTSFree with selected options. I not sure...

HI. Im in the same boat as you. I have the LGA 1150 as well. I started my Hac Build this morning. In the UNIBEAST step, I went to the DSDT down loads. Only to fined my DSDT is not there. Have you made any progress?