On one of my systems I noticed some weirdness cropping up with bluetooth keyboard and mouse after installing the iMessage fix in Chimera... spurious key and mouse presses. When I tried to remove and re-add my Apple wireless keyboard, it won't re-associate properly now either.
After some...
It's a 512 disk, but your comment jogged me to check the partition. It's an Apple Partition Map. Formatting another identical drive (same model, size) as a GPT works, so Chameleon must have a bug when encountering Apple Partition Map.
The 5770 glitching was the same with and without...
Yep, worked good once I was not booting off the USB 3 ports. Looks like almost everything is working, great guide, thanks very much!
Two issues I have run into:
I have a Intel 80gb SSD on SATA 0, a Vertex 2 SSD on SATA 1, and a LG Bluray on SATA 2. Machine works fine. If I have my...
FFS ... Smart of Gigabyte to put two USB 3.0 ports in the middle between USB 2.0 ports. I had the flash drive in the USB 3 ports. Looks like it's going now.
RK
Howdy, I tried following this guide ... so far, not so good.
I have the Z68MA-D2H-B3 v1.3 board with a i5-2500k and 16gb RAM, I flashed the UEFI code onto it fine. In the UEFI setup, I went to the last page and loaded optimized defaults for all settings, then set AHCI, the graphics memory and...
Re: Boot problems when adding SATA drives
I figured it out. I repartitioned both of the drives and now both work.
They were MBR, and since they are not boot drives I made them Apple Partition Map and they now work fine. It was either the MBR, the fact that they previously held ZFS partitions...
Ok so here's a strange one; I have a Gigabyte GA-P45-UD3P board, and it's working perfectly with 10.6.6. I used the latest iBoot and Multibeast this evening to get it up and running. I used a edited DSDT, and the BIOS is in AHCI mode for all SATA ports. Since I have a 5770, I used the Chameleon...
Howdy, I replaced my wife's machine with a nice new X58a system with a 480GTX and it's running great.
I'd really like to get her old one back up with a fresh install, and the DSDT I have for it isn't quite working properly (KPs on shutdown, never could get sound working, etc.) so I wonder if...
Ok so, I'm having a devil of a time with audio on this board - a Gigabyte GA-P45-UD3P, firmware FB. I'm using AsereBLN's DSDT file for this exact board/firmware. I've loaded via Multibeast the DSDT, the Realtek 1000 driver and the LegacyHDA.kext for 889a. The rest of the system is 10.6.4 all up...
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.