Recent content by moaiad

Sure I use iMac 18.3 , before that I use iMac 17.1 and didn't work good with RX580 I use DSDT and no need for SSDT CPU power management

finally you were right , there is no need for kext like whatevergreen.kext , that what make the problem of freezing and high cpu need just to use board-id patch and disable igpu. FCXP now render on 11 sec. and system not freezing. and work smooth. thanks and best regards

no , I use usbinjectall.kext and config patch for port limit today I remove Whatevergreen.kext and use config patch disable board-id check its working good for now

Hi there when I just use and without igpu my system freeze after 2 minute which kext you use for and rx580 ? and is there special config.plist for clover? best regards

thanks I will check I use shiki kext , after a lot of work finally I got vtdecode and vt encode not taking cpu before that it was cpu 300% and system freeze on photo.app I enable hardware decode for AMD but if u say 15 sec so I think you are right and maybe FCPX using iGPU

BruceX benchmark 1:30

Full System , work like a charm ..

Samsung SM951 NVme 128GB

hi, i have the same problem after updating to 10.8.2 i found that the fix is to replace AppleACPIPlatform.kext and every thing is ok i hope this will help you kind regards

hi, yesterday i got my gigabyte gtx670 OC 2GB , for installation i use GraphicsEnabler=No , for first time boot also use GE=No i use dsdt for my MB , and multibeast 5.0.1 , dont install Hardwaremonitor and NVIDIA SMC . the system work perfect . the problem of stucking on pci...

Hi, for 6870 users just backup the ati6000controler.kext from the usb , delete it and go with the installation . after finishing the installation install the ati6000controller.kext back to the mountain lion hd and your gfx will work.