Recent content by loureads

Well, I messed up the multibeast and had to re-do the whole thing again. I wasn't sure what you meant by this part at all. Also my RAM Issue turned out to be a non-issue. I was wrong about what I had installed.

I have not re-inserted the GTX card back into the machine. I just wanted to get it working. The graphics card isn't that important to me at the moment. Below are the requested screen grabs from inside Mojave. I haven't run the Multibeast yet. Still looking into what all the options mean. One...

SUCCESS! I re-created the installer with Unibeast following the guidance from post 6 on the config. One change I made was to turn Verbose ON in the config and turn the Timeouts from 3 (which was always a real slowdown on the whole process) to 0. I realize that the timeouts give you time to get...

Ok. I will try this. But one question. Are you saying I should do all these steps [ √] Inject Intel FakeID : 04128086 *-platform-d=0D220003 Return to Options and go to System Parameters -> ENTER -> System Integrity Protection and ENTER and Edit the checkBoxes as shown in the Uploaded Image...

Well, it took me a few times to get the changes you suggested right. (had an issue with using the mouse to select the FAKEID crashing the whole thing. I have not been able to make VERBOSE mode work with the added changes. I check it and nothing happens. Just goes into Apple loading screen. This...

Sorry for my lack of specifics. 1) Remade the installer with Unibeast - Selected EUFI & INVIDIA Inject 2) Mounted USB successfully into clover 3) Launched Mojave installer off USB and got to Installer Screen 3) Ran Disk Utility to Erase the target SSD drive (which is the drive I used to have my...

Success! (of sorts). Thanks for the amazingly detailed help & suggestions. 1) I remade the installer. 2) Successfully got into installation mode. 3) Reformatted old internal drive in DU and then installed Mojave. 4) Installed finished and rebooted machine. 5) Went right to Apple loading screen...

I did remove the card entirely so I'm good there. I also checked and made sure that the plist looked the same as all the images you posted and finally updated the BIOS from 4 to 6. So this time the OS progress bar makes it all the way to the end and just stays there. Never actually gets to...

Ok I think I got everything here.

Hello. Thanks for your answer. I removed the NVIDIA and am just using the onboard HDMI instead. I tried the installer again and now it doesn't fail and reboot to Boot0. Instead now it just hangs at the logo and about 1cm of progress bar. I did the Verbose thing and the main thing I take away...

Hello. I've been having a heck of a trying to get Mojave going. 1. Got Unibeast to make my USB installer (16gb Sandisk). It makes a Install Partition and a UEFI partition. 2. When I boot PC to Bios I select the UEFI partition and it boots into Clover. 3. Then I select Install Mojave and it...

Ha! Well, thank you. I get a little lost on this site. Too many places to look for info! Trying this solution now.

I have been having a hell of a time getting this made. I waited until the HS was ready to install, quit, formatted drive, ran unibeast and then this happens. Tried it twice. Not sure what I've done wrong...

So one problem I had was I holding down the wrong F key... so I was getting this instead of what you had. I changed the boot 1 to the mac OS drive. Still hanging... ___________ EUREKA! I found realized that blue screen you showed had some of the things I hadn't been able to find and turned...

Could you please take a screenshot of what you're talking about? I think I know what you're saying but a visual would be helpful. TIA!