Stuck on white apple logo with loading bar.

Hello my friends,

Today i was trying install OS x on my desktop (intel 6600k, Asus strip gtx 970, Asus z170 pro gaming motherboard) i followed the steps of the installation guide. But every time it got stuck on the white apple logo with the loading bar on 0% like on the picture.

Please help me, Greetings Kota.

Please put your specific motherboard model into the system configuration area on the left. It's hard to give you good advice without having that information on hand on every post (just the first one isn't enough).

Then, have a look at the http://www.tonymacx86.com/el-capitan-desktop-guides/179221-skylake-starter-guide.html

Thanks a lot for the quick respond i readed the hackintosh skylake page, did wat you said and came a bit further. It started downloading until and it finished but then i got this:
Does somebody know what to do with this?

Greetings Kota.

Please boot verbose (space bar from the Clover menu) and post a photo of where it stops.

If the last text is "Still waiting for root device" then either you need the IOAPIC fix or the USB fix from the Skylake Starter Guide -- if it comes to that please post your config.plist for review.

This is what it said (sorry for the bad quality don't know what happend to my screen)
The last sentences are missing bleutoothcontroller, waiting fot root device.





Greetings Kota.

So, since you got the Still waiting for root device message, please post your config.plist for review

Im searching for the config.plist but i can't find it on the bootable usb, Where can i find it?

Greetings Kota.

View attachment config.plist Here is the config.plist.

Greetings Kota.

You should remove the IntelGFX FakeID in config.plist -- that is not needed and can only cause problems.

This config.plist does not have either the USB fix or the IOAPIC fix. I'm a little confused because I thought you would have put those in a few posts ago. In any case, you should put those in (from the http://www.tonymacx86.com/el-capitan-desktop-guides/179221-skylake-starter-guide.html) and try again.

You should make sure you're looking at (and saving to) the config.plist at EFI/CLOVER/config.plist on the EFI partition of your USB install drive. You can mount the EFI partition with e.g. EFI Mounter v3 or Clover Configurator.

I did try it with the USB fix and the IAOPIC fix. But everytime when i try to boot my computer using the bootable usb it emties the config.plist. So when i send you the config.plist i forgot to edit in the fixes, sorry for that. I just tried to boot again using the USB fix, the IAOPIC fix and i removed the intel gfx fakeID but i still get the "no entry sign". And when i boot it in verbose mode it still says:
1 unsupported protocol USB 03,01
failed to allocate port,
Missing bluetooth controller
And: Waiting for root device.
Here a more clear photo of the verbose mode (still waiting on root device stays under it):

And the config.plist:
View attachment config.plist

Any more thoughts of what it could be?

Greetings Kota.