ASRock z68 Extreme3 Gen3 DSDT Request

Hello, everyone.

I am creating my first Hackintosh on this new hardware and was looking for some assistance in creating a DSDT I could use with MultiBeast. My specs are as follows:

ASRock Z68 Extreme3 Gen3 MB with Patched 2.30 BIOS per other thread suggestions
Intel Core i5 2500k
8GB Corsair RAM
Installed on 128GB SSD
Using on-board Intel HD 4000 graphics right now, will place my HD 7950 in once I get the system up and running normally.

My extracted DSDT is attached below. Thank you for your assistance and let me know if anything else is required.

Take the graphics card out or disconnect the power.

Set the BIOS as per below.

Advance > Advanced\North Bridge Configuration
Primary Graphics Adapter > Onboard* (When you install graphics card change this option to - GPU)
Share Memory > 64MB*
Render Standby > Disabled*

Advanced\South Bridge configuration
Deep Sleep > Enabled in S5*

Advanced Storage Configuration
SATA Mode > AHCI*
Hard disk SMART > Enabled*

Advanced\Super IO config > Serial Port - Disable

Advanced ACPI config
Suspend to RAM > Disabled*
ACPI HPET Table > Enabled*
RTC Alarm power on > by OS*
reset of the option here is disabled.

Not so imp settings but runs the system quite. Once you boot in fans are controlled by OSX.
HW Monitor
CPU FAN > Level 2
Chassis fan settings > Level 4

Fresh mountain Lion installation > http://www.tonymacx86.com/downloads.php?do=file&id=155

Update the OSX to - 10.8.3 and reboot.

Download the attached DSDT and keep on the desktop.

Download Multibeast for Mountain Lion and run it with the below settings and reboot > http://www.tonymacx86.com/downloads.php?do=file&id=155



If you do the above steps correctly you should have a perfectly working hackintosh.

-