Contribute
Register

Z68X-UD3H-B3 + Gigabye GTX 550 ti, Black Screen after Install

Status
Not open for further replies.
Joined
Nov 7, 2011
Messages
9
Motherboard
GA-Z68X-UD3H-B3 F12
CPU
Intel i5 2400
Graphics
Gigabyte GTX 560 TI
Mac
  1. MacBook
  2. MacBook Pro
  3. Mac Pro
Classic Mac
  1. Apple
  2. Color Classic
  3. eMac
  4. iBook
  5. iMac
  6. Power Mac
Mobile Phone
  1. iOS
  2. Other
I've gone through the UniBeast 3 install, had to run with flags -x GraphicsEnabler=Yes. But now when trying to load into installed partition I am getting just a black screen. I've tried with all flags in the guide, but have had no luck.

Any ideas?
 
Got the same board but with GTX680. Did you try "GraphicsEnabler=Yes PCIRootUID=1"?
 
Yeah, tried that. tried every combo I could figure out and saw on here.

Sorry its the GB GTX 560 ti.

I even tried setting the Graphics Mode via flag, but no luck either.

But I did remove the Card, and was able to boot without any flags, so it's definitely something there. I'm going to at least get it going as is for now, then try to figure out this card stuff in a bit.
 
Update: After applying multibeast, cannot boot without -x flag. Thats a shame.
 
type the following:

PCIRootUID=0 GraphicsEnabler=Yes IGPEnabler=No
 
Alright, So GTX 560 ti is back in. @scotty the IGPEnabler must of done the trick, but I applied it through MB.

Booted -v only and all was good.

Reapplied Multibeast with my DSDT file. All seems to be good.

New snag though, no MAS, iCloud, etc. But ill troubleshoot that and through any updates. Unless anyone has any suggestions.
 
type the following:

PCIRootUID=0 GraphicsEnabler=Yes IGPEnabler=No

Thank you so much it worked for me too
but i cannot set this in MB
 
It worked great for me (GraCa: GeForce GTX 560 Ti ), thank you!
 
Status
Not open for further replies.
Back
Top