Yosemite Multibeast 7.0.1 Installation Failure

[TheNikOne]

Hello everybody,

when I try to run multibeast, it fails to install. I read all the last threads from the people who have the same problem-> I tried to run: sudo kextcache -system-caches, sudo kextcache -update-volume / (http://www.tonymacx86.com/multibeast-bug-reports/142963-multibeast-install-failure.html)
but I didn't get back any results.

I didn't find the multibeast.log.

Are there any new reasons why the installation could fail on a clean new install of Yosemite?

My system:
- CPU Intel Core i5 4670 @ 3.40 Ghz
- nVidia GeForce GTX 770 OC (Gigabyte)
- Z97M-D3H (Gigabyte)

Sorry if there are any mistakes, I'm German.

 

[UtterDisbelief]

MultiBeast should install on your system...

You don't specify what hard-drive you are using.

It's a long-shot but whenever I have had problems installing MultiBeast options it is because I need to modify the disk format using Terminal:

http://www.tonymacx86.com/25-boot0-error-official-guide.html

As I say a long shot but it might help. I know you are booting OK but I have found that if MultiBeast won't install it's plists and kexts following the 4k instructions helps.

After this I check my SMBios.plist with Chameleon Wizard.

(If you try, remember to boot from UniBeast, go to Disk Utility and Unmount the hard-disk and take a note of its disk designation (disk0s2 etc) so you can use this in the command line.)