- Joined
- Aug 3, 2014
- Messages
- 26
- Motherboard
- Gigabyte Z97N-WIFI - F7
- CPU
- i7-4790K
- Graphics
- RX 580
- Mac
- Mobile Phone
Hackintosh was built by the Stork's instructions for Hector. Added RX 580 and Lilu+WEG to L/E with Hackintool and updated it to 10.15.2 from 10.13.6.
I have a problem with USB (3.0). I tried to make my own SSDT like on this video (Instructions by @RehabMan). As the video says I also added USBInjectAll to L/E. Also tried with FakePCIID and FakePCIID_XHCIMux. All kexts were last available Release version.
At the motherboard panel (2x USB 2.0, 4x USB 3.0), I get all the plugged devices at EHC1 and EHC2 controllers instead of XHC. So 2x USB 2.0 reads USB 2.0 and USB 3.0 devices (at USB 2.0 speeds) with ECH2@1A controller,
on the other hand, 4x USB 3.0 only reads USB 2.0 devices with EHC@1D controller. Wierd.
The front panel has 2x USB 3.0, but only 1 detects USB 2.0 and 3.0. The second one is 'dead' (light on USB thumb is on, it doesn't recognize it nor 2.0 nor 3.0, but it works OK in Win10).
The working one is running USB 3.0 speeds with XHC@14 controller (but SS, not HS like in the video). If I plug in 2.0 device it goes back to EHC1@1D controller.
------------------------
Any help would be great as I do not know how to proceed and change al these EHC controlled USBs under XHC to proceed and make own SSDT like in the video.
I've also attached config.plist. TIA, Urban!
I have a problem with USB (3.0). I tried to make my own SSDT like on this video (Instructions by @RehabMan). As the video says I also added USBInjectAll to L/E. Also tried with FakePCIID and FakePCIID_XHCIMux. All kexts were last available Release version.
At the motherboard panel (2x USB 2.0, 4x USB 3.0), I get all the plugged devices at EHC1 and EHC2 controllers instead of XHC. So 2x USB 2.0 reads USB 2.0 and USB 3.0 devices (at USB 2.0 speeds) with ECH2@1A controller,
on the other hand, 4x USB 3.0 only reads USB 2.0 devices with EHC@1D controller. Wierd.
The front panel has 2x USB 3.0, but only 1 detects USB 2.0 and 3.0. The second one is 'dead' (light on USB thumb is on, it doesn't recognize it nor 2.0 nor 3.0, but it works OK in Win10).
The working one is running USB 3.0 speeds with XHC@14 controller (but SS, not HS like in the video). If I plug in 2.0 device it goes back to EHC1@1D controller.
------------------------
Any help would be great as I do not know how to proceed and change al these EHC controlled USBs under XHC to proceed and make own SSDT like in the video.
I've also attached config.plist. TIA, Urban!