- Joined
- Nov 19, 2017
- Messages
- 39
- Motherboard
- Dell 3567
- CPU
- i3-7020U
- Graphics
- HD 620
- Mac
- Mobile Phone
Ok, try thisNO ): I don't know what could be wrong /:
Ok, try thisNO ): I don't know what could be wrong /:
Nope that didn't work out either /: , do you think ACPIBatteryManager may be interfering with the kext? I read in some post that in some cases it, is there a way to see if voodooIC2HID is working? or the logger?Ok, try this
run these 3 commands in terminal:1)
If I install v2.3 to /L/E or /S/L/E , it cause hanging during boot.
v2.2 had no problems.
I can use v2.3 only clover injected kext mode.
2)
How can I load i2c touchpad in recovery boot?
Although I should boot recovery hd to solve problem ‘1)’, in recovery mode touchpad does not be recognized.
*Catalrina prevent read-write volume in single-mode. So I can’t delete kext from /L/E boot with single mode.
sudo spctl --master-disable
sudo mount -uw /
sudo killall Finder
Nope that didn't work out either /: , do you think ACPIBatteryManager may be interfering with the kext? I read in some post that in some cases it, is there a way to see if voodooIC2HID is working? or the logger?
Hey but do you have the trackpad at least working? Because I don't know what I did but I got the trackpad working without gestures and it was no showing at the preferences but when I shut it down it stopped working $: at least I'd like to have it working you know just to free an USB port hahaI have the same model as you, (Dell 3590 with i5 and GTX 1650) and I already have more than 2 months trying to make these i2c kexts work, but without success (and I still haven't found anyone that has managed to make it work on the 3590). I believe that for our model, no gestures on the trackpad.