Update Directly to macOS High Sierra

[me.home]

Would people recommend me waiting until the new high Sierra version of multi beast is released before updating?

Why do you want to wait ?
In case you need some kexts from the Beast I guess all from 10.12 will still work on 10.13.

I did inplace upgrade, just dl via Applestore und followed he instruction from page 1 and only audio needed a "new" fixing.
However if you have known to be problem hardware you should just wait till 10.13.1 or .2 is out.

 

[me.home]

where are the kexts I should copy to /EFI/CLOVER/kexts/Other/??
same for apfs.efi
thanks

Page 1 is APFS.efi to dl ! You'll need to register / login of course !
And your kexts are from your hidden efi partition you have to mount and then backup the kexts that may be there....

 

[cumik2]

Real soon now. Be patient. Besides, HS 10.13.0 is full of bugs. So, hang in there and get some sleep.

thank you for your response

 

[Acden]

SSD

Why do you think only for SSD? It words on HDD either.

 

[robert78901]

Updated without problems. Wi-fi works fine with 10.12 drivers and I get my audio working with this voodoo hda https://github.com/chris1111/VoodooHDA-macOS-High-Sierra

 

[In-N-Out]

I stated SSD because it was specifically optimized for SSD. I shouldn't have said only SSD's since it can also be used on HFS+HDD's.

 

[Wolfster]

Why do you want to wait ?
In case you need some kexts from the Beast I guess all from 10.12 will still work on 10.13.

I did inplace upgrade, just dl via Applestore und followed he instruction from page 1 and only audio needed a "new" fixing.
However if you have known to be problem hardware you should just wait till 10.13.1 or .2 is out.

Thanks for the reply. I followed the instructions but have had issues trying to boot back into the Mac OS install. Described here(also with a fix):

https://www.tonymacx86.com/threads/kernel-panic-on-high-sierra-installation.233227/


I guess what I’m asking is will this problem be addressed through the new multibeast, and if so I might as well wait before upgrading to make sure the fix is permanent.

 

[Yamel]

My USB keyboard and mouse doesn't work after the update and I'm stuck in the login screen.

Somebody can help me.

 

[ozz3110]

Fully working on my HP 6300, thank you very much!

 

[mkstretch]

What version of Clover are you running there? Make sure you are at the right version r4173 or newer. Make sure you only have the minimum kext running, just FakeSMC.kext in /EFI/CLOVER/kexts/Other/
and the apfs.efi in /EFI/CLOVER/drivers64UEFI/

Verify that the config.plist that you are using is the right one. Also note that the system will reboot about 3 times during the install process. Good luck!

I’m running the lastest clover. When you ask if I’m using the right config.plist I’m not sure? How do I find out? Thanks