Contribute
Register

Unibeast USB won't boot past Chimera GA-H67N-USB3 (SOLVED)

Status
Not open for further replies.
Re: Unibeast USB won't boot past Chimera GA-H67N-USB3

Thought I should leave y'all with an update:

Tried a million things and then extra-thoroughly returned to some to make sure I hadn't missed anything, here's what I did to fix it:

-I was using a VGA cable, every boot combination didn't work including "GraphicsEnabler=No"
-Switched to HDMI and used "GraphicsEnabler=No" and it worked great. Apparently VGA is a no-go even when trying to boot on this MB.

Now I'm stuck trying to boot my Lion drive post-install. GraphicsEnabler and Verbose got me through the boot to a blue screen, shortly followed by grey apple screen with mouse working but stuck here.

Good luck getting this far!
 
Hi Guys

Also used Unibeast on new Custom MacMini2011 Build.

I get past chimera, through verbose, get apple logo screen with mouse support, then osx desktop does not show.

Is it possible to use Unibeast to go staight to 10.7.2 with the following hardware

i3 2100 CPU
GA-H67N-USB3-B3
Onboard Graphics (HDMI)
8GB Corsair 1333 RAM (2x4gb Kit)
60GB OCR SSD Connected Via Sata2
?

[Update] I am an idiot.
After a good 12 hours trying to get Lion to show me a desktop instead of a Mouse Cursor and Apple Logo I realized the following.
The Chip I purchased for this build (i3 2100) has HD2000 onboard Graphics.
So I have 2 choices.
1 - Purchase i3 2105
2 - Purchase seperate Graphics Card which is compatible with Lion
Do not know which way I am going to go at this point.
3am = Sleeping on it
 
Status
Not open for further replies.
Back
Top