Unibeast 10.3.0 not completing USB install creation

[mrjayviper]

setup:

• I'm running Unibeast inside my MBP2017 running catalina.
• Unibeast have been give access to removable+network volumes

problem:

Unibeast is stalling on the point where it's installing (or trying to install) Clover. It was stuck at this process for more than hour. I tried running it 3 times (with a macOS restart in between tries) and no luck there.

Thanks you.

EDIT: I have 2 MBP2017s and 1 iMAC 2017 but they are all running Catalina. I'm only mentioning this in case you want me to try on an older version of macOS.

 

[P1LGRIM]

UniBeast Troubleshooting Notes

Before posting an issue or question with UniBeast please read the following: 1. UniBeast does NOT install anything on your hard drive, it CREATES a bootable USB stick. 2. UniBeast only works on English language systems and is not supported using any other language. 3. UniBeast is not...

www.tonymacx86.com

 

[Dandelion]

Hello,

I'm running Yosemite 10.10.2 on my 1st Hackintosh and I'm trying to create the Unibeast files onto my USB. I'm getting an error that I Couldn't Create USB Installer.

USB Disk Description : Kingston DataTraveler 2.0 Media Total Capacity : 15.48 GB (15,483,273,216 Bytes)
Connection Bus : USB Write Status : Read/Write
Connection Type : External S.M.A.R.T. Status : Not Supported
USB Serial Number : 60A44C413A8CB Partition Map Scheme : GUID Partition Table

I'm selecting Unibeast > Catalina > Legacy Boot Mode > Inject INVIDIA... password, then I get the ERROR.

Any idea what might be the hold up? Much appreciated!