Contribute
Register

uh oh... Did I put a m.2 ssd where I need to install a wifi card?

Status
Not open for further replies.
Joined
Oct 4, 2015
Messages
10
Mac
  1. 0
Classic Mac
  1. 0
Mobile Phone
  1. 0
Total N00b here.

So I got my hackintosh up and running and was in the process of installing multibeast when I went to install my wifi card, it looks like it requires a M.2 port. However, I think I used the only m.2 port on my motherboard for a m.2 ssd drive.

Can you double check and make sure that my wifi card requires the m.2 slot? And if so, can you also double check and make sure that I only have one M.2 port on my motherboard?

If I only have one m.2 port on my motherboard, is there some other wifi card that you would recommend that I could use that doesn't require the m.2 port on my motherboard.


WIFI CARD: BCM94352Z NGFF M.2 Wifi to 867 Mbps card 22*30mm
https://www.amazon.com/dp/B00JGFA50U/?tag=tonymacx86com-20

MOTHER BOARD: Gigabyte H170N Wifi
http://www.gigabyte.com/products/product-page.aspx?pid=5552#sp

Let me know if you need anything else.

Thx.
 
Total N00b here.

So I got my hackintosh up and running and was in the process of installing multibeast when I went to install my wifi card, it looks like it requires a M.2 port. However, I think I used the only m.2 port on my motherboard for a m.2 ssd drive.

Can you double check and make sure that my wifi card requires the m.2 slot? And if so, can you also double check and make sure that I only have one M.2 port on my motherboard?

If I only have one m.2 port on my motherboard, is there some other wifi card that you would recommend that I could use that doesn't require the m.2 port on my motherboard.


WIFI CARD: BCM94352Z NGFF M.2 Wifi to 867 Mbps card 22*30mm
https://www.amazon.com/dp/B00JGFA50U/?tag=tonymacx86com-20

MOTHER BOARD: Gigabyte H170N Wifi
http://www.gigabyte.com/products/product-page.aspx?pid=5552#sp

Let me know if you need anything else.

Thx.
States clearly in your motherboard info that you have 2 M.2 slots - one for the wifi module and one on the back for storage. I suggest you check you installed the storage in the slot on the back of the board.
 
Status
Not open for further replies.
Back
Top