Trying to boot Clover into OSX El Cap installation. Skylake and Z170 board

[makoa]

Build

• CPU: Intel i7 6700k Skylake Quad Core LGA 1151
• Motherboard: MSI Gaming Intel Z170A Chipset, Atx
• PSU: Corsair 750w
• HD: WD Black 4TB 7200
• SDD: Intel 480GB
• Memory: 32 GB RipJaws (4x8GB) 288 pin DDR4

I've already inserted a bunch of patches mentioned in Tony Mac threads about Skylake and Z170s. I'm hoping someone can look at my screen when I boot in Verbose and tell me what's going wrong/what I still need to patch.

 

[BreBo]

Did you disable the Serial Port in BIOS?

 

[julian200601]

What MSI Z170A board are you using?

 

[kiiroaka]

Does it boot okay with just one RAM stick installed? (I've read on some forums that some MSI boards have RAM slot problems - same with ASUS 170 boards and Corsair RAM). Verify each RAM stick works in the first slot. Use a wrist strap after powering off the PC, pulling the power cord and depressing the Power On button until the green LED on the mobo goes out.

Then add a second stick, and lastly the last two sticks (to make sure you don't have dead mem slots).

Do you have a video card installed? Do you have built-in video ports available? If so, remove the video card and see if it boots fine.