Contribute
Register

[Solved] The problem of freezing graphics RX 580 in the program final cut pro 10.14.1

Status
Not open for further replies.
macnb said:
it's macOS registry file from the attached App.
Run it, and Save File as...
...then zip and post here.
Click to expand...
excellent
For the graphics card, I need to enter a code or a specific command
Or a special patch needs to be registered with this application.
Please advise on this.
 
zankofilm said:
excellent
For the graphics card, I need to enter a code or a specific command
Or a special patch needs to be registered with this application.
Please advise on this.
Click to expand...

Huh ?
I gave you instructions.
Run it, Save File as..
...then zip the file and post here.
 

Attachments

  • zankozryan’s iMac.ioreg
    6 MB · Views: 53
zankofilm said:
file
Click to expand...
Your file shows:
  1. You are using wrong SMBIOS model model (iMac18,3).
    For your Haswell CPU, you should use iMac15,1. Generate a new SMBIOS for your config.plist.
  2. You have not enabled your IGPU.
    In BIOS, set your AMD card as Primary/Initial display card and enable Intel Graphics as secondary.
    In config.plist,
    Graphics->Inject->Intel=yes
    Graphics->ig-platform-id=0x04120004
    Devices->FakeID->IntelGFX=0x04128086
    Boot->Arguments->shikigva=60
Then test.
 
macnb said:
Your file shows:
  1. You are using wrong SMBIOS model model (iMac18,3).
    For your Haswell CPU, you should use iMac15,1. Generate a new SMBIOS for your config.plist.
  2. You have not enabled your IGPU.
    In BIOS, set your AMD card as Primary/Initial display card and enable Intel Graphics as secondary.
    In config.plist,
    Graphics->Inject->Intel=yes
    Graphics->ig-platform-id=0x04120004
    Devices->FakeID->IntelGFX=0x04128086
    Boot->Arguments->shikigva=60
Then test.
Click to expand...
wow:clap::clap::clap::clap::clap::clap:
Apparently the problem was resolved
Thanks to all these tips, dear friend
 
zankofilm said:
wow:clap::clap::clap::clap::clap::clap:
Apparently the problem was resolved
Thanks to all these tips, dear friend
Click to expand...

Great. Well done.
Did you use the suggestions I gave above or resolved the problem using another solutions ?
 
macnb said:
Great. Well done.
Did you use the suggestions I gave above or resolved the problem using another solutions ?
Click to expand...


Yes
With the help of you and the same commands, the problem was solved
thank you again
 
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top