Hi
@markoskz - just wanted to follow up with you about our
previous conversation regarding my WiFi/BT module: The M.5 adapter card arrived, and the WiFi / Bluetooth card I ordered fits it perfectly. I installed it into the upper slot on my board because the lower slot interferes with the case I'm using a bit, so the upper was my only option. The WiFi and BT did NOT work out of the box, but after following a few of the setup instructions for this card I'm able to get the WiFi working perfectly. However, I cannot get the BT to work at all. The MacOS simply does not see the hardware, no matter which tutorial I've tried, or which combination of various kexts I add to either the clover bootloader or into /System/Library etc.
I have also installed Windows 10 on another drive in this case, and dual boot perfectly. Windows also is able to use the WiFi without any issue, and claims it can see the Bluetooth card, but I'm not able to actually connect any BT devices to the Windows side at all. I suspect the card may be faulty, as it is obviously from a used laptop.
So, for now, my Hackintosh works perfectly with the only exception of Bluetooth, which I can live with for now. If I really need BT in the future, I can try a different Broadcom module, or I can always pick up a USB -> Bluetooth dongle.
Have you received your adapter for your Broadcom chip yet? Have you been able to try it? Any success or failure to report?
If you can get a reliably working solution for BOTH WiFi and Bluetooth (particularly one that does not require any extra kexts or other drivers - just works OOB) I'd be thrilled to try it as well on my build.
Thanks!