[SUCCESS] NUC PC intel i9 8950HK, 6 cores, 12 threads, 32 GB DDR4 2666Mhz

[bouba411]

Hi,
I succesfully installed mac os mojave 10.14.4 on this :


1) Use Tonymacx86 guide to create usb boot stick

UniBeast: Install macOS Mojave on Any Supported Intel-based PC

The following guide is a complete walkthrough for updating to or installing a fresh version of macOS Mojave. It requires no experience and all of the basic installation and post-installation tools are available on tonymacx86.com. Table of Contents Step 1: Download macOS Mojave Step 2: Create...

www.tonymacx86.com

2) Use theses Bios Config :



3) boot from the USB key and install Mojave as directed by tonymacx86 guide.

4) reboot from the USB key, mount your efi partition with Clover configurator latest edition.
In the EFI partition, open Efi folder and replace your clover folder with this one (unzipped of course) :



5) restart ! That’s all folk !
Anything except wifi works like a charm.


IMPORTANT:
The most important part is the CSM config on BIOS because without it, you have to wait for 5 minutes at each boot before getting keyboard and mouse to work.
For the wifi, I haven’t found the right kext yet. It’s quickiest to change it (the wifi card) with a broadcom one. That seems to works out of the box.

Thanks to

kabauterman

www.tonymacx86.com

shumbola

www.tonymacx86.com

 

[willumpie82]

Thanks for this! I ordered an I5 quadcore last friday at Alixp. would I be able to use the same procedure and clover.zip you provided?

 

[bouba411]

97% sure. I tested it on i7 and i9 With success.

 

[kabauterman]

I'm pumped seeing how for you have come.

I just have some problems left.

let me know if you get HDMI Working in Mac OS.

 

[bouba411]

HDMI fully working. No lag.
See this attachement: 2048 Mo fully recognized.

 

[kabauterman]

HDMI fully working. No lag.
See this attachement: 2048 Mo fully recognized.

View attachment 418142

I do not see anything about HDMI there. Have you connected your Display via HDMI Connector? Not via Display-Port?
For me HDMI is not working in any configuration.

I will try to play with your CLOVER.zip

 

[bouba411]

I am connected via hdmi and nothing else.

 

[bouba411]

I do not see anything about HDMI there. Have you connected your Display via HDMI Connector? Not via Display-Port?
For me HDMI is not working in any configuration.

I will try to play with your CLOVER.zip

Yes give my clover folder a try.

 

[willumpie82]

Hi guys, i tried to install but during the install it reboots on the following line in the logfile

it seems to fail with th e error it is unable to convert to APFS and the machine reboots

formatted the drive samsung 970 evo pro (from the root device) to JHFS+

 

[willumpie82]

how could i debug the installer? at the point of the previous post the machine reboots but in the CLOVER menu i get a second bootable drive (my ssd) If i run verbose on that drive, it shows a lot if info but switches back to apple progressbar and than at 10%(ish) it reboots again but i get no logging

I also noticed that not al USB ports are suitable for install, the front USB stops loading during installer boot. when i switch to the rear USB (bottom) it boots into installer fine.