It might be worth trying the following (with RX 5700 XT installed):
If this fails, remove the radpg boot argument and:
- Add boot argument radpg=15 and reboot.
- Disable WhateverGreen by adding the boot argument -wegoff
- Restart and check again.
Hello - I am stuck with a stupid problem it seems. I boot into the installer all good and goto disk utility to format the brand new NVME drive (Kingston) and no matter which format and scheme I choose it instantly freezes at Creating Partition Map.
Damn, I have 2 HDMI and 2 DP, both the DP don't workHey @CaseySJ so used the radpg=15 and got the same result again just like @heyelly
I then attempted with -wegoff and as it stands it’s been on for over 20 mins now Without a reboot, as @heyelly mentioned it does cause a loss of DisplayPort but only 2 of them the 2 that are to the left of the HDMI. I am still able to use HDMI and solo DisplayPort to the right of the HDMI.
So I assume this narrows down that the reboot issue is being caused by WEG?
If this continues to work it’s at least a temp fix and I’m still able to use dual monitors just instead of dual DisplayPort it’s 1 and 1. Until WEG gets and update and hopefully fixes :/
Damn, I have 2 HDMI and 2 DP, both the DP don't work
You are partially right, I was using other version of OcQuirks, but now I tried with your version (-4.efi witch 26,208 bytes) and the problem still exists if I dont use MemoryAllocation.There is not single case of a bricked motherboard because of OsxAptioFix2Drv-free2000. The severity of the author's warning is totally inconsistent with reality. In other words, when someone screams the sky is falling but nothing of any kind happens to the sky month after month and user after user, what shall we think about the warning? This is the power of Fear, Uncertainty, and Doubt.
Nevertheless, your drivers folder contains:
- Which version of OcQuirksare you using?
- The standard release version from the Github website?
- The one we built for this motherboard (OcQuirks4-efi)?
- Does your system boot normally with just:
- OcQuirks-4.efi (this is the special one tailored for Z390 boards)
- and slide=0