- Nov 11, 2018
- Gigabyte Z490 Vision D
- RX 580
- Classic Mac
- Mobile Phone
If iGPU is already enabled in BIOS then nothing needs to be changed there. Only need to set platform ID to 0x3E9B0007 and use one of your USB-C to DisplayPort cables. But fully remove the 5700 GPU.@CaseySJ So tried to BOOT using my M2P slotted NVMe Main Clone- Same result as SSD.
about 10 mins of idle with no input and computer reboots back to clover menu.
Also tried, X.M.P- Disabled which dropped ram from 3200mhz to 2133mhz
Still gave me the same result as prior, 10 mins idle, reboot back to clover boot.
Im assuming the next item would be different GPU or iGPU test to see if its GPU causing the reboot after extended idle?
I may just grab another GPU tomorrow to test with rather than having to mess with BIOS and config to switch to iGPU
Anything else outside of that you would recommend I try? Was there anything within the EFI I shared yesterday that you would suspect?
Any thoughts on new clone and attempting to switch to OC?