- Joined
- Dec 5, 2013
- Messages
- 56
- Motherboard
- ASUS ROG Maximus IX Hero
- CPU
- I7-7700K
- Graphics
- RX 580
- Mac
- Mobile Phone
Kexts look OK, though I don't know what NoVPA.jpeg.kext does (I don't have that one). I'm not sure, but, there may be a conflict with the two APTIO efi drivers - I suggest you pick one. I do not have VBoxHFS, but do use HFSPlus. My ApfsDriverLoader is named differently than yours (non-64).
The `NoVPA.jpeg.kext` is just a temporary solution to get quick look and preview working, the other solution is to enable iGPU, which I can do in bios but my system stops booting with the error message I mentioned in one of my the previous replies.
I would rather need a helping hand on the drivers because it's not easy to test their need, because you cannot disable them in clover, and if something is missing the system might stop booting. Furthermore I have no idea which are needed or not. Most of them were probably there when I started building the system. Over the time with the clover issue I added some manually (remember when clover updater deleted some), but I don't remember which one I added. I need to find out which drivers are meant what for and what's the difference between the `non-64` versions. It seems confusing to me that on a 64bit system one would use non-64 versions of the drivers.
Again I have no idea where `VBoxHFS` is from, maybe VirtualBox installed them, which seems quite unlikely since it's inside the clover folder.
In looking through your config, if you are using the current Lilu + WhateverGreen, you should remove the Intel GFX information - no Fake ID and no ig-platform-id. Lilu + WhateverGreen auto-determine this. Also, I don't believe you should have "disablegfxfirmware" boot flag set (I don't).
About the WhateverGreen and Lilu, I read that some people don't use these kexts with an AMD graphics card, but other do. This is quite confusing to me, but I haven't tried disabling them and trying to boot. I will experiment with the other flags and check if they are required or not.
IIRC `disablegfxfirmware` was needed to boot into High Sierra back then, but I'm not sure if it's still required.
Of course, make sure Clover & Clover Configurator are current.
I keep it always up to date, of course after other tested it properly.
---
I would still appreciate if you could share your config file (with removed or re-generated SMBIOS) so I can compare the flags and patches more in depth.