- Joined
- Jun 7, 2019
- Messages
- 101
- Motherboard
- Z490 Vision D
- CPU
- i9-10900K
- Graphics
- Sapphire RX Vega64
- Mac
Yes - I did that to test the SSDT. If you want to flash the original firmware back - use the tbpatcher from GitHub
sudo ./tbpatch patch -p RP@21 -f patch2.plist.
or you can use the external programmer as before or boot into Windows and update the firmware for the TB device.
The only benefit I see is that USB-C devices are getting detected connected to the TB port. I haven't tested extensively so do not know the other benefits.
@mango1122 So I was able to restore to the original firmware using tbpatch. Thank you for the patch and the tip! Saved me the hassle of removing the MB from the case to flash back.
I tried both DC & D8 versions of the SSDT. Mine's at RP21@1B,4 but curiously just like @fontanero the System Report > Thunderbolt section gets populated only with the D8 version of your SSDT.
With the new SSDT however, I'm facing kernel panics (see attached for details) when resuming from sleep. In most cases, the system goes to sleep just fine but I always get this panic when waking up.
I do not get KPs when using @CaseySJ's version of the SSDT but TB3 stops working after sleep until a restart.
I've tried my Clover EFI as well as your OC EFI and get the same results. I've tried various BIOS Settings (related to Above 4G Decoding & CSM) with the same results. The only thing I haven't touched yet are the TB3 Settings. They're set to the ones you recommended for the modded patch. Those are next on my list.
Any ideas as to what might be going on? If not, given everything I've tried, I'm going to disassemble the system this weekend and do a clean install with minimum devices e.g. iGPU only vs my 5700XT etc.