- Joined
- Jul 15, 2018
- Messages
- 14
- Motherboard
- ASUS ROG Maximus Hero X
- CPU
- i7-8700K
- Graphics
- MSI Radeon RX 580 ARMOR 8GB
- Mac
- Mobile Phone
Hey All,
I am hoping the collective brains trust might have an answer for this one...
I updated from High Sierra to Mojave this week (being the up to date guy I am) and am having what i think is an odd boot issue. For the update I:
For the most part, it worked fine and I am typing this from 10.14 (less sound) but... I have noticed two strange things:
1: Even though I updated Clover to the latest version, it still says it's booting from the previous version.
2: If I disconnect the previous boot drive (Disc0, Container disc4), the system will not boot. So it seems it is oddly still referencing the Clover install on the old drive.
I have been through this install twice now, having done something odd to the last one while attempting to get sound on blew the boot time out to minutes. I noticed the above issues with the first update as well, but have decided to sort this side of it, so I can clone the install, before tacking the sound issues again.
I am sure it's something small, but any help/advice greatly appreciated and I have attached my config, just in case there's something in there that I can't see.
Cheers,
Gerard
I am hoping the collective brains trust might have an answer for this one...
I updated from High Sierra to Mojave this week (being the up to date guy I am) and am having what i think is an odd boot issue. For the update I:
- Carbon Copy Cloned the running 10.13.x install (on Disc0, Container disc4) to a new SSD called 'Mojave' (Disc7, Container Disc8).
- Rebooted into 'Mojave'.
- Used Multibeast to make Mojave bootable (CCC does not seem to make an automatically identifiable boot drive).
- Rebooted.
- Ran a direct 10.14 update on 'Mojave'.
For the most part, it worked fine and I am typing this from 10.14 (less sound) but... I have noticed two strange things:
1: Even though I updated Clover to the latest version, it still says it's booting from the previous version.
2: If I disconnect the previous boot drive (Disc0, Container disc4), the system will not boot. So it seems it is oddly still referencing the Clover install on the old drive.
I have been through this install twice now, having done something odd to the last one while attempting to get sound on blew the boot time out to minutes. I noticed the above issues with the first update as well, but have decided to sort this side of it, so I can clone the install, before tacking the sound issues again.
I am sure it's something small, but any help/advice greatly appreciated and I have attached my config, just in case there's something in there that I can't see.
Cheers,
Gerard