[Solved] Sierra won't boot after MultiBeast installation

[OlofS]

Hi everyone, I would really appreciate some help.

I followed the installation guide, managed to install Sierra and boot it, at which point I ran MultiBeast 9.2.1. I was unsure what drivers to choose for audio and network so I didn't install any (thinking I could do it later). After successful installation, I rebooted and got stuck on the boot screen, with the progress bar at around 60%. Attached a picture of the verbose prints.

After several attempts at booting, I figured I'd re-do it all from the beginning, but I can't even boot from the USB I used to perform the initial installation...

Hardware is GA Z270N-WIFI and Core i3-7100, Samsung EVO 850 ssd, no graphics card.

Any ideas what to do?

Thanks in advance,
Olof

 

[BreBo]

After successful installation, I rebooted and got stuck on the boot screen, with the progress bar at around 60%. Attached a picture of the verbose prints.

There are changes to the new 10.12.5 / 10.12.6 Intel graphics drivers which may cause black screen or hang on boot.

Try to boot with a FakeID (0x12345678).
At Clover Boot Screen select Options > Graphics Injector > FakeID and enter 0x12345678

When you reach the desktop, install the kexts (Lilu.kext and IntelGraphicsFixup.kext) to /Library/Extensions using KextBeast.

 

[OlofS]

That worked! Thanks a million!

 

[Garyloffler]

Thanks, this helped me as well.

 

[Yullator]

LEGEND, this solved all my problems !

 

[laurentiuronea]

There are changes to the new 10.12.5 / 10.12.6 Intel graphics drivers which may cause black screen or hang on boot.

Try to boot with a FakeID (0x12345678).
At Clover Boot Screen select Options > Graphics Injector > FakeID and enter 0x12345678

When you reach the desktop, install the kexts (Lilu.kext and IntelGraphicsFixup.kext) to /Library/Extensions using KextBeast.

Hi!


I got the same problem. Could you please help me?
I'm using this laptop:
https://goo.gl/JcPPMd

Specs:

MB: Hewlett-Packard 183E (U3E1)
CPU: 2.2 GHz Intel Core i7-3632QM
GPU: Intel HD Graphics 4000 and AMD Radeon HD 7670M

EFI partition:
https://goo.gl/v5TewT

Here I attached a demo with the problem.
https://goo.gl/cp5E8M

These are the last lines that appear on my screen:
https://goo.gl/hjuzd2

I really appreciate any kind of help.
Thanks in advance!

 

[sumsaykra-z]

There are changes to the new 10.12.5 / 10.12.6 Intel graphics drivers which may cause black screen or hang on boot.

Try to boot with a FakeID (0x12345678).
At Clover Boot Screen select Options > Graphics Injector > FakeID and enter 0x12345678

When you reach the desktop, install the kexts (Lilu.kext and IntelGraphicsFixup.kext) to /Library/Extensions using KextBeast.

Brebo,

I've posted elsewhere trying to get around this same issue attempting to install 10.12.6 on this same board. I'm using the latest clover bootloader (4200) and I've also attempted with the one that comes on Unibeast currently. I attempted this Graphics Injector and this did not work for me I also tried loading those two kext at boot and no luck. Same issue.