- Joined
- Oct 30, 2012
- Messages
- 83
- Motherboard
- DELL G3 3779
- CPU
- i5-8300H / HM470
- Graphics
- HD630
- Mac
- Mobile Phone
Hello,
my config was: Gigabyte GA-Z77-DS3H with Sandy bridge CPU i3 2105 HD3000. The system worked beautifully until I decided to change processor with Ivy Bridge HD4000 (i3 3225).
So I upgrade my system with a processor i3 3225 hd4000 (replace i3 2105 hd3000).
Then everything goes wrong.
I was downloaded new config.plist for HD4000 from this guide (config.plist Standard), but then I got this error:
pullmode [1] txringsize [256] txsendqsize [1024] reapmin [32] reapcount [128]
The picture with the error is attached.
It turned out that I can run the software, but only by vebrose mode and without sound driver. If I install sound, the system brings me back to the above error.
Does anyone have any suggestions on how to return the system working or need to do a fresh installation?
my config was: Gigabyte GA-Z77-DS3H with Sandy bridge CPU i3 2105 HD3000. The system worked beautifully until I decided to change processor with Ivy Bridge HD4000 (i3 3225).
So I upgrade my system with a processor i3 3225 hd4000 (replace i3 2105 hd3000).
Then everything goes wrong.
I was downloaded new config.plist for HD4000 from this guide (config.plist Standard), but then I got this error:
pullmode [1] txringsize [256] txsendqsize [1024] reapmin [32] reapcount [128]
The picture with the error is attached.
It turned out that I can run the software, but only by vebrose mode and without sound driver. If I install sound, the system brings me back to the above error.
Does anyone have any suggestions on how to return the system working or need to do a fresh installation?
