- Joined
- Sep 7, 2012
- Messages
- 60
- Motherboard
- Dell Optiplex 3060 MFF
- CPU
- i5-8500T
- Graphics
- HD 630
I have a Lenovo M700 Tiny with specs in my signature. I tried to install Sierra on it, but I ran into some issues. I followed the Sierra guide here: https://www.tonymacx86.com/threads/...ierra-on-any-supported-intel-based-pc.200564/ With some help from this thread here: https://www.tonymacx86.com/threads/almost-sucess-lenovo-m700-tiny-i5-6400t-intel-hd-530.206992/
Here's what I did in addition to the guide:
In BIOS
Devices-->video setup--> change auto to IGD, and then preallocated memory to 64MB from 32
After Install disk creation, fill out the "Memory" key in the SMBIOS section of Clover's config.plist under the EFI partition. Due to kernel panic during boot.
<key>Memory</key>
<dict>
<key>Channels</key>
<integer>2</integer>
<key>SlotCount</key>
<integer>2</integer>
<key>Modules</key>
<array>
<dict>
<key>Slot</key>
<integer>0</integer>
<key>Size</key>
<integer>4096</integer>
<key>Frequency</key>
<integer>2133</integer>
<key>Type</key>
<string>DDR4</string>
</dict>
</array>
</dict>
During clover boot selection screen, turn on Clover -> Options -> PCI Devices -> USB Ownership
After install, I still have to choose USB Ownership again and boot from the internal HD
Multibeast install
Audio -> Universal -> VoodooHDA
Network -> Inter -> Maui
Customize -> Intel HD 5xx
iMac 17,1
That's about it. After the final reboot, I removed the USB drive to boot from internal SSD. It got stuck half way through. I attached a screenshot with verbose turned on. I can't tell from the messages on screen what is wrong. Can anyone help?
Here's what I did in addition to the guide:
In BIOS
Devices-->video setup--> change auto to IGD, and then preallocated memory to 64MB from 32
After Install disk creation, fill out the "Memory" key in the SMBIOS section of Clover's config.plist under the EFI partition. Due to kernel panic during boot.
<key>Memory</key>
<dict>
<key>Channels</key>
<integer>2</integer>
<key>SlotCount</key>
<integer>2</integer>
<key>Modules</key>
<array>
<dict>
<key>Slot</key>
<integer>0</integer>
<key>Size</key>
<integer>4096</integer>
<key>Frequency</key>
<integer>2133</integer>
<key>Type</key>
<string>DDR4</string>
</dict>
</array>
</dict>
During clover boot selection screen, turn on Clover -> Options -> PCI Devices -> USB Ownership
After install, I still have to choose USB Ownership again and boot from the internal HD
Multibeast install
Audio -> Universal -> VoodooHDA
Network -> Inter -> Maui
Customize -> Intel HD 5xx
iMac 17,1
That's about it. After the final reboot, I removed the USB drive to boot from internal SSD. It got stuck half way through. I attached a screenshot with verbose turned on. I can't tell from the messages on screen what is wrong. Can anyone help?