- Joined
- Jun 3, 2018
- Messages
- 43
- Motherboard
- ASUS Prime H310T/CSM
- CPU
- i5-8400
- Graphics
- UHD 630
- Mac
- Mobile Phone
Hi,
I had finished my system install on i5-8400/ASUS Prime H310T/WD Black SSD (gen2). I originally chose APFS to be my file system; the system installed correctly. However, after I set up my system with Multibeast and rebooted, I lost power button and all USB response (on both USB 3 ports and both USB 2 ports) on my system when I boot into both recovery and the main system on the internal drive; USB still work on the Clover screen for both internal drive and (external) installation stick.
I now decided that I will not use APFS on my computer, but instead HFS+, which gives me a chance to re-setup MultiBeast. What could be causing the problem, and what settings should I use?
(I did it wrong and now my drive is converted to APFS upon install... not a big problem. If I notice lags, I will switch back to HFS+)
I had finished my system install on i5-8400/ASUS Prime H310T/WD Black SSD (gen2). I originally chose APFS to be my file system; the system installed correctly. However, after I set up my system with Multibeast and rebooted, I lost power button and all USB response (on both USB 3 ports and both USB 2 ports) on my system when I boot into both recovery and the main system on the internal drive; USB still work on the Clover screen for both internal drive and (external) installation stick.
(I did it wrong and now my drive is converted to APFS upon install... not a big problem. If I notice lags, I will switch back to HFS+)
- System installation stick made with UniBeast; the following kexts is added aside from those provided with UniBeast:
- IntelGraphicsFixup.kext
- USBInjectAll.kext
- XHCI-300-series-injector.kext
- GenericUSBXHCI.kext
- /EFI/CLOVER/drivers64UEFI/ contains OsxAptioFix2Drv-64.efi
- The fresh SSD was formatted with APFS
the first time. The current install formatted it as HFS+. - Original MultiBeast settings are as follow:
- QuickStart > UEFI boot mode
- Drivers > Audio > H310 / B360 / H370 / Q370 Audio Device ID Patch
- Drivers > Misc > FakeSMC, FakeSMC Plugins, FakeSMC HWMonitor
- Drivers > Network > RealtekRTL8111 v2.2.2
- Drivers > USB > 3rd Party USB 3.0, USB InjectAll
- Bootloaders > Clover UEFI Boot Mode
- Customize > Graphics > Intel HD 6xx, Intel Graphics Fixup
- Customize > System Definition > MacMini6,2; original definition was 27" iMac (most likely iMac14,2)
- Additional information from System Info:
- appearently, all four onboard USB port and possibly all mid-board expansion ports are attached to "USB 3.1Bus", as shown:
- appearently, all four onboard USB port and possibly all mid-board expansion ports are attached to "USB 3.1Bus", as shown:
Last edited: