- Joined
- Dec 19, 2011
- Messages
- 11
- CPU
- Core i5
- Graphics
- Gigabyte HD6870
- Mac
- Classic Mac
- Mobile Phone
Hello all,
I recently upgraded my Lion disk to Mountain Lion. To do so, I had to remove my graphics card, install, and then replace it. After this process, my Windows 7 (installed on a different drive) hangs at "Starting Windows". I also notice that on the POST screen, BIOS takes much longer to load AHCI support. It used to instantly list AHCI after all of the hard drives. Now it hangs for a while before that pops up. I know that problems with SATA control can cause this type of hang... Normally I would think this is just a windows problem, but I had booted into Windows immediately before installing Mountain Lion and immediately after it hangs. I was just hoping someone had some insight to share.
Thank you!
I recently upgraded my Lion disk to Mountain Lion. To do so, I had to remove my graphics card, install, and then replace it. After this process, my Windows 7 (installed on a different drive) hangs at "Starting Windows". I also notice that on the POST screen, BIOS takes much longer to load AHCI support. It used to instantly list AHCI after all of the hard drives. Now it hangs for a while before that pops up. I know that problems with SATA control can cause this type of hang... Normally I would think this is just a windows problem, but I had booted into Windows immediately before installing Mountain Lion and immediately after it hangs. I was just hoping someone had some insight to share.
Thank you!