[solved] Clover Stuck on Row of Plus Signs when booting from SSD

[besttech]

Hello, I recently install high Sierra 10.13.3 on my HP Spectre x360 15t. The installation boots fine when booting from my install USB, but when the installation is booted from clover on the SSD, the installation stalls on a row of plus signs shown in the clover verbose.jpg.

It is puzzling because I'm using the same EFI folder as my clover USB, but it yields two different results.
I also attached my efi below.

 

[RehabMan]

Hello, I recently install high Sierra 10.13.3 on my HP Spectre x360 15t. The installation boots fine when booting from my install USB, but when the installation is booted from clover on the SSD, the installation stalls on a row of plus signs shown in the clover verbose.jpg.

It is puzzling because I'm using the same EFI folder as my clover USB, but it yields two different results.
I also attached my efi below.

There are quite a few Spectre guides in the various laptop guides forums.
Perhaps you will find the clue there...

 

[besttech]

I found the issue, I wasn't booting from the PreLoader.efi/loader.efi that I needed to on this machine.
Mentioned in steps 5 and 6 in this guide https://www.tonymacx86.com/threads/guide-sierra-on-hp-spectre-x360-native-kaby-lake-support.228302/
Now it boots normally.
Thank you

 

[RehabMan]

I found the issue, I wasn't booting from the PreLoader.efi/loader.efi that I needed to on this machine.
Mentioned in steps 5 and 6 in this guide https://www.tonymacx86.com/threads/guide-sierra-on-hp-spectre-x360-native-kaby-lake-support.228302/
Now it boots normally.
Thank you

Yup.

Marked solved.