- Joined
- Jun 1, 2017
- Messages
- 17
- Motherboard
- Aorus GA-Z270X-Gaming 7
- CPU
- Intel i7-7700K
- Graphics
- HD630
Hi Hackintosh gurus
This is my first build and I'm a complete novice hence the never ending problems. The build portion went so well that the installation had to have all the hiccups.
The problem:
The bootloader successfully loads but then when initiating the installer (in verbose mode) it shows 2 rows of text then hangs on the infamous row of:
+++++++++++++++++++++++++
My system:
All settings are correct as far as I know (copied from this successful build)
Clover Tweaks (changed from standard Unibeast installer):
(See my EFI folder attached)
BOOT
The above changes I took from this thread. I have been trying off of a USB 3 drive but will try with a USB 2 drive tonight.
Side Question: Would it be worth it to rather install High Sierra due to it natively supporting NVMe drives out of the box?
Thank you very much to all who will help me out
This is my first build and I'm a complete novice hence the never ending problems. The build portion went so well that the installation had to have all the hiccups.
The problem:
The bootloader successfully loads but then when initiating the installer (in verbose mode) it shows 2 rows of text then hangs on the infamous row of:
+++++++++++++++++++++++++
My system:
- Mobo: GA-Z270X Gaming 7
- CPU: i7 7700K Kabylake
- RAM: Corsair Vengeance RGB 32GB
- Storage: 2 x Samsung 960 EVO NVMe SSD
All settings are correct as far as I know (copied from this successful build)
Clover Tweaks (changed from standard Unibeast installer):
(See my EFI folder attached)
BOOT
- Slide = 0
- FixOwnership = true
- Kernel CPU = true
- FakeCPUID = 0x0506E3
- All IONVMe Family Kexts added ( I only have a 960 EVO to install on)
- Trust = True
- DataHubDxe added
- EmuvariableEufi added
The above changes I took from this thread. I have been trying off of a USB 3 drive but will try with a USB 2 drive tonight.
Side Question: Would it be worth it to rather install High Sierra due to it natively supporting NVMe drives out of the box?
Thank you very much to all who will help me out