Contribute
Register

Sierra Install Problems (First Build)

Status
Not open for further replies.
Joined
Sep 15, 2017
Messages
4
Motherboard
ASUS H110M
CPU
Intel i5-6600k
Graphics
Nvidia PNY GTX 1060
Specs: Mobo: ASUS H110M
Graphics: GTX 1060
CPU: intel i5-6600k

Sorry if this is the wrong place to put this issue but I can’t figure out this problem after hours of troubleshooting. I have tried every single clover configuration imaginable and I still can’t get past the black apple logo screen. It gets to about 90% every time and then stalls out with the spinning wheel of death. I have tried both using the integrated motherboard graphics and using my video card but it doesn’t seem to make a difference. When running in verbose mode this is what I get:
Unfortunately I haven’t had any luck and I don’t really understand what the kecks editor it and how I would upload a config file to it. It’s also worth noting that all my bios settings adhere to the standards laid out in the installation section. This means that vt-d is disabled, secure boot is disabled, xchc handshake is enabled, and OS is set to other. Thanks in advance if you can provide any insight!
 

Attachments

  • 8B7AD46D-33D0-4786-AEF8-A063C3B98991.JPG
    8B7AD46D-33D0-4786-AEF8-A063C3B98991.JPG
    4.9 MB · Views: 158
Also worth noting, I am now getting an error: Architecture couldn’t be recognized! PMC_Boot_42 = 0x00000013
 
Your image shows an active Serial port (SuperIO) which should be disabled in your BIOS settings.
 
While I don’t disagree with you in my Bios I have gone to Advanced>Onboard Devices>Serial Port Config>Disable. I can’t find anything else in my bios that would allow me to disable a serial port. Any thoughts?
 
After working almost 24 hours straight I am getting some different errors but almost the same. Any help ideas?
 

Attachments

  • 326258AC-36F0-43FC-AE2E-FC7935829247.jpeg
    326258AC-36F0-43FC-AE2E-FC7935829247.jpeg
    4.7 MB · Views: 124
Status
Not open for further replies.
Back
Top