- Joined
- Jun 16, 2019
- Messages
- 47
- Motherboard
- Gigabyte Z390 Gaming X
- CPU
- i7-9700
- Graphics
- UHD 630
If you really want to try this card for Hackintosh, you will have to flash it to RX 570.
It needs special tool?
If you really want to try this card for Hackintosh, you will have to flash it to RX 570.
It requires ATIFlash on Windows and you need to find a specified video BIOS for it to flash.It needs special tool?
It requires ATIFlash on Windows and you need to find a specified video BIOS for it to flash.
Your i7-9700 contains UHD 630 that supports Catalina.If I don't use this card, Z390 hdmi(without Graphics Card) support Catalina hackintosh?
Thank you very much.Your i7-9700 contains UHD 630 that supports Catalina.
To use the HDMI port on the rear IO panel of the motherboard, please backup your existing config.plist and try the attached version. This version does the following:
In BIOS:
- Sets Platform ID to 0x3E9B0007 to drive a display monitor
- Sets framebuffer patches to enable the on-board HDMI port
Then connect display monitor to HDMI port on the back of the motherboard, and reboot.
- Set Internal Graphics to enabled (not auto)
- Set Initial Display Output to IGFX
You may also remove the RX 580 because that card will not be used properly. You can either (a) replace it with standard RX 580 or (b) flash a new standard VBIOS.
To confirm that iGPU is working, please post a screenshot of “System Information —> Graphics/Displays”.Thank you, it works.
I will use hackintosh without RX580 2048SP.
And thanks again