- Joined
- Jan 25, 2018
- Messages
- 4
- Motherboard
- MSI Z370 Gaming M5
- CPU
- Intel i3 8100
- Graphics
- GTX 1050Ti
Hi everyone i'm trying to enable the hw acceleration past 2 days and had no luck. I was running 10.15.4 when i plugged the RX 5700 then i tried so much but never get to use it with hw a. so i downgraded and clean installed the 10.15.3 but still no luck.
I tried: using different EFI folders from around, so much boot args and so much work on clover configurator that i cant even begin to list but i can try anything as requested.
When i try to open UNIGINE Valley it opens on CPU.
When i checked the Hardware Acceleration in VideoProc it shows enabled with CPU and doesn't even recognized the GPU.
I tested the GPU with LuxMark and get 25280 points as a result.
This is probably irrelevant but the fans aren't spinning due to zero rpm thing and i checked the fans while running LuxMark and saw them spinning.
My system:
- MSI Z370 Gaming m5
- MSI RX 5700 Gaming X (non XT)
- i3 8100
- Single module 8 GB 2133 Mhz RAM
- SanDisk Ultra 2 120 GB SSD
So is there anything i can do? Thanks in advance...
I tried: using different EFI folders from around, so much boot args and so much work on clover configurator that i cant even begin to list but i can try anything as requested.
When i try to open UNIGINE Valley it opens on CPU.
When i checked the Hardware Acceleration in VideoProc it shows enabled with CPU and doesn't even recognized the GPU.
I tested the GPU with LuxMark and get 25280 points as a result.
This is probably irrelevant but the fans aren't spinning due to zero rpm thing and i checked the fans while running LuxMark and saw them spinning.
My system:
- MSI Z370 Gaming m5
- MSI RX 5700 Gaming X (non XT)
- i3 8100
- Single module 8 GB 2133 Mhz RAM
- SanDisk Ultra 2 120 GB SSD
So is there anything i can do? Thanks in advance...