- Joined
- Aug 6, 2014
- Messages
- 6
- Motherboard
- Mavericks
- CPU
- i7
- Graphics
- Nvidia GTX 760
- Mac
- Classic Mac
- Mobile Phone
Hi everyone,
I am very new to the Hackintosh world, and my start is not going really well...
The instalation of Mavericks is done via UniBeast. But after, I need to use MultiBeast for the drivers.
I have this set-up, following the August Buyer's guide:
ASUS SABERTOOTH X79 Intel Core i7-4930KGeForce GTX 760
32GB RAM
512 Go SSD
Here are a few issues:
Wich one should I use between EasyBeast, UserDSDT & DSDT-Free?
After rebooting, I have the boot0 Error. I fixed it with the command:
dd if=/usr/standalone/i386/boot1h of=/dev/disk0s2
But after rebooting again, I have the apple logo and then, nothing. The monitor doesn't detect anything.
"DVI No Signal"
How can I fix this?
Does anyone has the same config and get the sound working?
Thanks a lot for you help.
I am very new to the Hackintosh world, and my start is not going really well...
The instalation of Mavericks is done via UniBeast. But after, I need to use MultiBeast for the drivers.
I have this set-up, following the August Buyer's guide:
ASUS SABERTOOTH X79 Intel Core i7-4930KGeForce GTX 760
32GB RAM
512 Go SSD
Here are a few issues:
Wich one should I use between EasyBeast, UserDSDT & DSDT-Free?
After rebooting, I have the boot0 Error. I fixed it with the command:
dd if=/usr/standalone/i386/boot1h of=/dev/disk0s2
But after rebooting again, I have the apple logo and then, nothing. The monitor doesn't detect anything.
"DVI No Signal"
How can I fix this?
Does anyone has the same config and get the sound working?
Thanks a lot for you help.