Post-install boot issue - Kernel Panic (CPU 10) with Asus z370-G

[Talli]

I've successfully installed Catalina 10.15.2 on my Asus ROG Strix z370-G (i7-8700) but get a kernel panic when trying to boot into the OS becuse it seems that

The BIOS is v2202 and I'm using a SATA drive.

The topline error I'm getting is:

"panic(cpu 10 caller 0xffffff801546520a): Kernel trap at 0xffffff7f978ce3d0, type 14=page fault"

I've attached images in addition to my Clover folder. Kexts are:

Any help would be very much appreciated!

Thanks in advance.

 

[Talli]

Does anyone have some thoughts on this issue? I would appreciate some feedback. Thanks!

 

[pastrychef]

Does anyone have some thoughts on this issue? I would appreciate some feedback. Thanks!

Try using the latest Clover EFI from my Asus Z370-G build thread. Link is below in my signature.

 

[Talli]

Thanks so much! I'll give it a try.

 

[Talli]

Hi @pastrychef

I've received a different error and hopefully this represents progress, though it's still a kernel panic.

After modifying your config.plist to represent my system (I use the onboard graphics so downgraded the SMBIOS to 18,1) I know receive a panic (CPU 2) error.

I've attached the EFI, the config.plist, and images of the error.

Your help is once again very much appreciated!

 

[pastrychef]

Hi @pastrychef

I've received a different error and hopefully this represents progress, though it's still a kernel panic.

After modifying your config.plist to represent my system (I use the onboard graphics so downgraded the SMBIOS to 18,1) I know receive a panic (CPU 2) error.

I've attached the EFI, the config.plist, and images of the error.

Your help is once again very much appreciated!

Please try this and see if it makes any difference.

Are you installing Catalina?
What hard drives, optical drives, and SSDs do you have installed?

 

[Talli]

Hi @pastrychef

Unfortunately I'm still getting a KP (CPU 2). Error report attached.

I see that you disabled the following DSDTs:

change PEGP to GFX0
change PPMC to PMCR
change EC0 to EC

Any other suggestions?

Thanks!

 

[pastrychef]

Hi @pastrychef

Unfortunately I'm still getting a KP (CPU 2). Error report attached.

I see that you disabled the following DSDTs:

change PEGP to GFX0
change PPMC to PMCR
change EC0 to EC

Any other suggestions?

Thanks!

Are you installing Catalina?
What hard drives, optical drives, and SSDs do you have installed?

 

[Talli]

I have a Seagate 4GB SATA drive. No optical or SSD drives attached.

I've successfully installed Catalina 15.2 but I'm not able to boot into the initial set up pages. In other words I've passed the 30 minute installation of Catalina but the system crashes upon the following boot.

Does this make sense?

 

[pastrychef]

I have a Seagate 4GB SATA drive. No optical or SSD drives attached.

I've successfully installed Catalina 15.2 but I'm not able to boot into the initial set up pages. In other words I've passed the 30 minute installation of Catalina but the system crashes upon the following boot.

Does this make sense?

I don't get it... You are getting AHCI errors... Please try this one...