Contribute
Register
I'm trying to get my Celeron G3930 to boot with no luck.
I have tried both, @Gigamaxx and @chowhar config.plist with no success.

Any help/guidance would be appreciated.

UPDATE 1: I figured one of my problems out... I was using OpenCore 0.5.9 files and the config.plist found on here is for 0.5.7. After downgrading my OC files to 0.5.7 I'm able to boot into macOS Recovery. Will update if able to complete macOS installation.
Try disabling the kernel patches for the Haswell chips. There are 2 of them I believe.
 
Screen_Shot_2020-07-27_at_8.09.17_PM.png

Still have some bugs to work out, but I am in... Thank you!
 
CPU: Pentium G3258
GPU R7 240 v2

OpenCore 0.6.1

Stuck at [EB|#LOG:EXITBS:START]

Any solution?
 

Attachments

  • config.plist
    24.2 KB · Views: 147
Try older version of OC?
R7 240 probably won’t get metal.
I used 0.5.8 too and other errors popped up.

Should I try with Clover?
Or it's a dead end because of GPU or smth?
 
I used 0.5.8 too and other errors popped up.

Should I try with Clover?
Or it's a dead end because of GPU or smth?
The GPU should not kill the install but it just won’t be useable for heavy loads.
Clover works for this install just to se the fake CPUID 0x0306A0, KernelPM AMD IntelPM
 
@Gigamaxx can you help me install Catalina using Clover on my G3258?
 
@Gigamaxx can you help me install Catalina using Clover on my G3258?
For Clover use:
Fake CPUID. 0x0306A0, or 0x0109E0
**NullCPUPowermanagement.kext
KernelPM
IntelPM
*=kext in Clover/Kexts/Other folder.
All other settings in Clover Binaries/ACPI and Kext and Kernel section (CPUID).
 
Should I use Unibeast’s guide to make the installer or another guide?
 
Should I use Unibeast’s guide to make the installer or another guide?
Unibeast should work, you can also use a clover build to replace the EFI if it doesn’t boot. Use clover Configurator to edit the config plist.
 
Back
Top