OS X 10.10 Yosemite on Gigabyte GA-Z68MX-UD2H-B3 in progress

[iDVD]

OS X 10.10 Yosemite with Clover on Gigabyte GA-Z68MX-UD2H-B3

Hardware:

• MB >> Gigabyte GA-Z68MX-UD2H-B3 rev..1.0.
• CPU >> Intel i5 2500k
• VGA >> Sapphire ATI HD5870
• RAM >> Corsair Vengeance 8GB 1600MHz
• SSD >> Intel 330 120GB
• PSU >> Zalman ZM750W
• BT >> GMYLE(Broadcom BCM20702 chipset)

Software :

• MB Bios >> U1E(UEFI BIOS)
• OS X Yosemite 10.10
• Clover r2976

Status:

Working:
​

• Sound Realtek ALC889 - cloverALC patch from toleda (link)
• Network Realtek RTL8111E - RTL8111.kext (link) or RealtekRTL81xx.kext (link)
• SSD Trim - Clover inj.(link)
• Bluetooth - bluetooth work out of the box
• Video - QE/CI working
• AppStore - Working
• iTunes Store - Working
• ​iCloud - Working
• iMessage - Working fixed by this guide
• FaceTime - Working

Not tested:
​

• USB 3 - Not tested
• Sata3 chip Marvell 88SE9172 - Not tested
• Sleep - Not tested
• SpeedStep - Not tested

Does not work:
​

• Booting screen resolution - Not Working

BIOS/UEFI Settings:
Screenshot gallery

CLOVER Settings:
Screenshot gallery

Clover installation: Guide here

Before I made clean install(actually I made few to make iMessage work) of Yosemite i had ML 10.8 in my system with unibeast and multibeast.
Now I working to make iMessage and FaceTime work. Try everything from this guide, but can't make it working.
Every time I trying to login iMessages getting this error "Could not sign in to iMessage. An error occurred during activation. Try again"


14/11/05 Update - iMessage fixed by this guide

 

[hbomb]

Did you ever test speedstep? I just converted from using multibeast and wondered how to get the power management functioning properly on the 2500k i5 sandy bridge.

 

[interpolgp]

I'm working on Native PM at the moment will post settings if I achieve it. Keep up the good work

 

[randycatanach]

Thanks for posting this. It definitely helped me finally switch over to clover.

One question though, why did you decide to check the "Asus AICPUPM" box if you're on a Gigabyte board?

 

[maddenterror]

You are a godsend.

 

[bkendig]

I'm also trying to get a GA-Z68MX-UD2H-B3 working with UEFI U1e, but Clover gives me a blank screen immediately after I select the boot volume (in verbose mode, right after the "root device uuid is" line - see http://www.tonymacx86.com/yosemite-...-mean-when-clover-hangs-root-device-uuid.html).

Which drivers did you install from the Clover installer's Drivers64UEFI section?

Would you please post a copy of your config.plist file?

 

[bkendig]

I've gotten it working and I'm now up and running (yay!). One more question, though: has anyone with this board gotten USB3 disks to mount?