Omen 15-ek0006nl not entering installer

[Feartech]

It's so damn difficult to start form scratch... I already tried 1 or 2 guides but no one worked...
I ll try to pick your EFI and make the changes you mentioned in your guide and post the results back here.

i only mentioned that your SMBIOS was a desktop one and that you should be using a laptop smbios, only takes an edit of your config.plist, as mentioned, check over post 2 from my guide

 

[taita87]

I checked the post but I don't know how to change the smbios

 

[Feartech]

I checked the post but I don't know how to change the smbios

use Propertree

 

[taita87]

I am editing the config.plist via textedit, I just don't know what string I have to change for SMBIOS

 

[Feartech]

I am editing the config.plist via textedit, I just don't know what string I have to change for SMBIOS

using textedit is not correct if not done properly

use plisteditpro or propertree on a mac

you may have ruined your config.plist by using textedit, best to get fresh clean config,plist and start again

 

[taita87]

I'm starting to understand how it works, but I'm getting other errors...
it keeps getting ACPI errors in a loop

 

[Feartech]

I'm starting to understand how it works, but I'm getting other errors...
it keeps getting ACPI errors in a loop

try without those extra .aml files you added

 

[Feartech]

I'm starting to understand how it works, but I'm getting other errors...
it keeps getting ACPI errors in a loop

you have 2 battery kexts:
ACPIBatteryManager.kext
SMCBatteryManager.kext
only 1 is required

LiluFriend.kext is pointless, remove it

VoodooInput.kext.dSYM is not a kext, remove it

also you have too many VoodooI2C* kexts, only use the ones needed

remove:
GenericUSBXHCI.kext

AppleBacklightInjector.kext is not needed anymore

 

[taita87]

you have 2 battery kexts:
ACPIBatteryManager.kext
SMCBatteryManager.kext
only 1 is required

LiluFriend.kext is pointless, remove it

VoodooInput.kext.dSYM is not a kext, remove it

also you have too many VoodooI2C* kexts, only use the ones needed

remove:
GenericUSBXHCI.kext

AppleBacklightInjector.kext is not needed anymore

which VoodooI2C are required? only VoodooPS2Controller?

I try to leave only SSDT-AWAC.aml and see what happens now

 

[Feartech]

which VoodooI2C are required? only VoodooPS2Controller?

I try to leave only SSDT-AWAC.aml and see what happens now

setup your voodooI2c after you have installed

you will probably still need EC and PLUG.aml

try fresh approach:

[Guide] Booting The USB Installer Using OpenCore

A guide in setting up your USB installer using OpenCore. You must have either a built-in ethernet or compatible Broadcom Wifi in your laptop for this guide to work. Built-in Intel Wifi can also work if set correctly...

www.tonymacx86.com