- Joined
- Dec 24, 2012
- Messages
- 16
- Motherboard
- Gigabyte Z390 I Aorus Pro WIFI
- CPU
- i5-9600K
- Graphics
- RX 580
- Mac
- Classic Mac
- Mobile Phone
Since many years my Hackintosh is really realiable and works really nice. But at the moment I got stuck. I wanted to use a new monitor with higher resolution than HD (1920*1200)
At the moment I use two monitors with (1920*1200) each one connected to one DVI Port. My system works well and I see the whole boot process at the monitor.
When I only connect the new 30“ monitor to the DVI Port and set up the resolution to (2560*1440) as ment to be. The picture is blurred, blocked and you can see the pixels and ist almost like the is no antialising. When is switch to lower resolution everything works fine. So maybe it is a problem with DVI and high resolution.
I wanted to test out connection via DisplayPort. But cant get any signal through this port. When booting with Monitor via DP I can see the BIOS Screen and boot screen, and then the screen goes black and nothing happens. i also tested other monitors and cables via DP. Still keeps going black. How can I enable the DP Port?
It is really strange because the card should work native with OSX.
Board:
GA-Z97X UD5H BK
GraphicCard:
EVGA 04G-P4-2768-KR NVIDIA GTX 760 Superclocked ACX Cooler, 4GB
At the moment I use two monitors with (1920*1200) each one connected to one DVI Port. My system works well and I see the whole boot process at the monitor.
When I only connect the new 30“ monitor to the DVI Port and set up the resolution to (2560*1440) as ment to be. The picture is blurred, blocked and you can see the pixels and ist almost like the is no antialising. When is switch to lower resolution everything works fine. So maybe it is a problem with DVI and high resolution.
I wanted to test out connection via DisplayPort. But cant get any signal through this port. When booting with Monitor via DP I can see the BIOS Screen and boot screen, and then the screen goes black and nothing happens. i also tested other monitors and cables via DP. Still keeps going black. How can I enable the DP Port?
It is really strange because the card should work native with OSX.
Board:
GA-Z97X UD5H BK
GraphicCard:
EVGA 04G-P4-2768-KR NVIDIA GTX 760 Superclocked ACX Cooler, 4GB