No Audio Devices - Realtek ALC AppleHDA [Guide]

[rplite]

Hello, What is the proper audio codec to use for an Asus Maximus VIII Impact/Skylake 6700k/Nvidia GTX980 build w/OS X 10.11.5 and using MultiBeast 8.2.3?

 

[Sylvan]

OK to rebuild cache.

Ok. I've been rebuilding the cache after every change so I don't think these files have anything changed since the last upload.

 

[rplite]

Thanks

 

[toleda]

Ok

Suggest a clean install.
Multibeast; 1150 only, no 100 Series selection
Reply with new files.

 

[toleda]

MultiBeast 8.2.3

Quick MultiBeast Setup for Skylake Systems 10.11.4+

 

[makproductions06]

boot log does not show realtekALC.kext loading and does show:

54:127  0:000      1 Kexts to patch
54:127  0:000       KextPatch[0]: 8 bytes, AppleAHCIPort

config.plist shows 3 patches.
Installed audio to a different EFI partition than the EFI partition booted.
Mount the boot EFI partition and run cloverALC again

So I unplugged all my other hard drives to make sure no other EFI was going to interfere, ran the script again, still no luck.

what else can i do

 

[toleda]

what else can i do

No files attached, no idea.

 

[makproductions06]

I'll attach newly made files..

 

[toleda]

I'll attach newly made files

Not much progress. See Problem Reporting, Post #1, attach all requested files.

 

[Sylvan]

Suggest a clean install.
Multibeast; 1150 only, no 100 Series selection
Reply with new files.

I just wiped my HD and did a clean install. Here are all the new files. Yes, I realize there is no codec. I tried to reset the codec per the instructions on page 1, but still, this is the result. Fresh install using clover / multibeast. I see that you linked a Skylake MultiBeast setup in post #1860 and that one shows the Realtek 100 series audio being installed. I will try that next.